Copy of Categories

The Resin Beast Categories for Placement are:

Large Model:
  • Models that were sold with a base size of at least 90mm or are over 20cm in height (bottom of foot to highest point of the model).
  • Maximum dimensions of 175x175mm square of 175mm round with a maximum height of 410mm.
  • One may submit Plastic or Resin Models for competition.
Mid-Size Model:
  • Models sold with a minimum base size above 40mm and a maximum base size below 90mm.
  • Maximum dimension of 100x100mm square or 100mm round with a maximum height of 300mm.
  • One may submit Plastic or Resin Models for competition.
Small Model:
  • Models sold with a base size equal to or below 40mm.
  • Maximum dimensions of 50x50mm square or 50mm round with a maximum height of 150mm for the entry.
  • One may submit Plastic or Resin Models for competition.
Diorama:
  • Minimum of 2 fully represented models. (Not one model and a hand rising out of the ground!)
  • Entry must be on a minimum of a 100mm round base up to a maximum of 200x200mm square or 200mm round, and with a maximum height of 410mm.
  • A Diorama may include a mix and match of models from both companies if desired but the cohesiveness will be considered. Tie break points awarded if done successfully.
  • One may submit Plastic or Resin Models for competition.
Unit or Warband:
  • This is a bit of a tricky one, so please read carefully.
  • Maximum base size for models in the composition is 60mm.
  • Units must be constructed using the following point system:
    • Models sold on a base smaller than 40mm are worth 1 point
    • Models sold on a 40mm - 60mm base are worth 2 points
    • Unit may have multiple base sizes in the unit.
    • Units must not have a value over 12 points or under 6 points.
    • This means that depending on the base size of the models you will have at minimum 3 models and at maximum 12 models.
  • A Unit/Warband may consist of a mix and match of models from both companies if desired, but the cohesiveness will be considered. Tie break points awarded if done successfully.
  • One may submit Plastic or Resin Models for competition.